Forster 7mm PRC Bushing Full Length Sizer Die with 3 Bushings

The Forster Bushing Full Length Sizer Die sizes the entire case while allowing outside neck diameter and headspace to be adjusted via replacement bushings for a perfect fit to any chamber. Bushings are sold separately or in combination with dies, allowing precise manipulation of case neck dimensions.SPECIAL NOTE: If using Forster Dies in a Forster Co-Ax press shellholders are not required since Forster presses do not require a shellholder.If using Forster Dies in any non-Forster press use shellholders that are recommended by the press manufacturer of the press being used. The sizing die is designed to resize the case neck's outside diameter and headspace length to keep the case neck in better alignment with the case's center line.The bushing can be adjusted (by using the die) for partial or total resizing of the case neck.Dies include three bushings (the sizes are what would most commonly be needed based on Forster's recommendation).Bushings are also available separately.