RYT Modified Case Jig Kit

The Modified Case Jig enables reloaders to easily and quickly make their own modified cases at home with a cordless drill, where a lathe or specialized equipment is otherwise typically needed. The kit is designed to drill and tap a 5/16x36 threaded hole in the primer pocket of once fired cases to fit widely available overall length gauges. This is the standard used in the old Stony Point gauges, Hornady Lock N Load OAL gauge and similar setups. The system uses a standard size 7/8x14 thread sizing die to grip the case to be drilled and tapped. This thread size is what the vast majority of RCBS, Redding, Hornady, Lee, and many other reloading presses and dies use. For presses using RCBS style shellholders, you simply install the die in the press, remove the shellholder and raise the ram. Then slide the shellholder into the ram while also sliding it over the head of the case. Once both are engaged, lowering the ram will remove the case from the die. If you're using a press with differe...