Case Club TSI2 & Rifle Pre-Cut Waterproof Case with Small Waterproof Box and Silica Gels to Help Prevent Rust

This Case Club TSI2 & Rifle case holds the imaged items in a waterproof hard case. The base foam holds the TSI2 (IWI bullpup) with or without optics, and the lid fits the imaged rifle with up to a 20″ barrel. Refer to the "Line Drawing" image for cut locations. The lid rifle is strapped into the lid via hook & loop, and is separated from the base TSI2 via an included foam divider sheet. The case accommodates mounted optics, foregrips, barrel extensions, collapsible or full stocks, and underbarrel lasers and flashlights. It also holds extra magazines, 2 silica gels (included), a small waterproof box (included), & extra shells. Does not fit side mounted items, large bipods, or pistol optics/lasers/flashlights. Pre-Cut foam is closed cell polyethylene that will last a lifetime. Included is a variety of perforations to fit a wide range of setups. Use the included razor blade to connect the perforations so you can accommodate your unique setup. Check out the "Line Drawing" to see the location of the pre-cuts! Case comes with a small waterproof box that has a designated cutout to store small items. Also included are 2 reusable moisture removing silica gel canisters to help prevent rust. The canisters have a built in viewing window that notifies you when saturated at which point you can recharge them by baking them in the oven. Once baked the canisters will be ready for use again. Case is made to withstand hard impacts. Padlock points for added security. Edge wheels allow the case to roll over smooth & rough terrain. Structural ribs added to the outside for increased durability. Wide bodied snap latches can be used with gloves, and can also be twisted for a psuedo lock. Built-in lid stay so the lid will stay upright when open. Case is shippable & is airline approved for checked luggage. O-ring gasket in the lid keeps water & dust out. Automatic pressure release valve in the front allows the case to equalize the atmospheric pressure when traveling to different altitudes. Case exceeds Airline Transportation Association (ATA) industry standards. Items imaged in the foam are not included. The product is for the case with pre-cut foam only. Check out the "Line Drawing" for the pre-cut shapes and locations!